30/ASSEMBLING THE ENGINE
Installing the shift drum locating
20.30
Installing the shift shaft
20.31
Installing the starter idler gear/torque limiter
20.32
Removing the crankshaft locking bolt
20.33
–
Push locking lever
locating
.
Info
The flat surfaces of the shift drum locating are not symmetric.
–
Release the locking lever.
–
Mount and tighten screw
Specification
600372-10
Screw, shift drum locating
–
Slide the premounted shift shaft
–
Press the sliding plate away from the shift drum locating. Insert the shift shaft all
the way.
–
Let the sliding plate engage in the shift drum locating.
The ends of the return spring must be in contact with the engine housing pro-
jection
600373-10
–
Slide on starter idler gear
–
Slide on washer
600374-10
–
Insert the bearing bolt.
–
Mount both needle bearings
600375-10
–
Remove special tool
Crankshaft locking bolt (113080802) (
–
Mount screw
Specification
Plug, crankshaft location
600384-10
away from the shift drum locating and position shift drum
.
M6
with the washer into the bearing seat.
.
with the recess facing outward.
. Mount lock ring
.
. Slide on torque limiter
.
with a new seal and tighten.
Loctite
®
10 Nm
(7.4 lbf ft)
.
P. 207)
M8
10 Nm (7.4 lbf ft)
140
243™