08/MASK, FENDER
Installing the front trim
12.6
Removing the rear fender
12.7
–
Connect the plug-in connector of the emergency OFF switch with the rip cord and
position the front trim.
–
Mount all screws.
–
Fully tighten screws
Guideline
Screw on fuel tank
–
Fully tighten screws
Guideline
Remaining screws, chassis
–
Install the front cover. (
301820-11
–
Remove the seat (
–
Remove screws
301822-10
–
Raise the rear of the air filter box lid
press on the carburetor connection boot to kink it at that location. This prevents the
carburetor connection boot from disconnecting from the carburetor.
–
Raise fender
301821-10
.
.
p. 69)
p. 63)
.
. At the same time, use your other hand to
at the rear and remove it.
M6
6 Nm (4.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
70