38/LUBRICATION SYSTEM
Mounting oil filter
25.4
Filling up with engine oil
25.5
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Pull the oil filters
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing area.
600138-10
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Fill the oil filters
600147-10
–
Oil the O-rings of the oil filter covers and mount them with the oil filter covers.
Mount and tighten screws
Specification
Screw, oil filter cover
–
Connect the ground cable
Specification
Screw, starter engine
600137-10
–
Remove the screw cap
Engine oil
–
Mount and tighten screw cap
600132-10
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
–
Start the engine and check that it is oil-tight.
Specification
Switch off the engine when the radiator fan switches on.
–
Check the engine oil level. (
and
out of the engine housing.
and
with engine oil and place in the oil filter container.
and
.
M5
on the engine and tighten the screw.
M6
on the clutch cover and fill up with engine oil.
2.00 l (2.11 qt.)
External tem-
perature: ≥ 0 °C
(≥ 32 °F)
External tem-
perature: < 0 °C
(< 32 °F)
.
P. 169)
168
6 Nm (4.4 lbf ft)
10 Nm (7.4 lbf ft)
Engine oil
(SAE 10W/50)
(
P. 203)
Engine oil
(SAE 5W/40)
(
P. 203)