Adjusting The Handlebar Position - KTM 450 SX ATV 2009 Setup Instructions

WORK

Adjusting the handlebar position

3.1
Removing the seat
3.2
–
Pull the instrument support off the handlebar and swing it to the side.
Info
Protect the vehicle and its attachments from damage by covering them.
Do not bend the cables and lines.
100100-10
–
Remove the four screws
ward and set it down.
–
Remove nuts
–
Remove screws
–
Remove screws
–
Place handlebar bridge
and tighten screw
Guideline
Screw, steering bridge
–
Mount and tighten screw
Guideline
Screw, steering column, top
–
Mount and tighten screws
Guideline
Screw, steering bridge
100099-10
–
Mount handlebar support
self-locking nuts
Guideline
Nut, handlebar support
–
Position the handlebar and fix it with handlebar clamps
screws .

Guideline
Screw, handlebar clamp
Info
Make sure cables and wiring are positioned correctly.
–
Position the instrument support on the handlebar.
–
Pull the release hook
remove from above.
100041-10
. Remove handlebar clamps

and remove handlebar support

and .
 
. Remove handlebar bridge

onto the steering column in the desired position. Mount

.

.

.

in the desired position using the screws. Mount new

and tighten.

back. Lift up the seat at the rear, pull it back and then

, swing the handlebar for-

with the screws.

.

M8 20 Nm
(14.8 lbf ft)
M20x1.5 25 Nm
(18.4 lbf ft)
M8 20 Nm
(14.8 lbf ft)
M10 45 Nm
(33.2 lbf ft)
. Mount and tighten

M8 20 Nm
(14.8 lbf ft)
4