Checking/Adjusting The Camber - KTM 450 SX ATV 2010 Repair Manual

61/ATV FRONT END

Checking/adjusting the camber

27.3
Info
The left and right camber should have the same settings.
The operations are the same on the left and right.
–
Jack up the vehicle. (
–
Loosen nuts
300273-10
–
Remove screws
300274-10
–
Insert tool

Camber gauge (83019014000) (
–
Check the camber on both heim joints.
» If marking
–
Turn tool
with the top edge of the A-arm.
–
Remove tool
300277-10
–
Position the A-arm with bushings
Guideline
Screw, A-arm top
300274-10
–
Align the heim joint at right angles to screws
Guideline
Nut, A-arm top
Info
All four heim joints must be checked and adjusted if necessary.
–
Remove the vehicle from the work stand. (
300273-10
p. 12)
.

with bushings .
 
in the heim joint and clip onto the A-arm.
p. 235)
is not aligned with the top edge of the A-arm:

with the heim joint in steps of 180° until the marking is in line

.

. Mount and tighten screws

.

M10x52 45 Nm
(33.2 lbf ft)
and tighten nut .
 
M12x1.25 30 Nm
(22.1 lbf ft)
p. 12)
193