MAINTENANCE ON CHASSIS AND ENGINE
Checking/adjusting camber
Info
The left and right camber should have the same settings.
The operations are the same on the left and right.
x
Jack up the vehicle. (
Loosen nuts
600128-10
Remove screws
Check parts for damage and wear. Replace damaged or worn parts.
600126-10
Insert the tool
Camber gauge (83019014000)
Check the camber on both heim joints.
»
If the marking
Turn the tool
line with the top edge of the A-arm.
Remove the tool
600127-10
Position the A-arm with the bushings
Specification
Screw, A-arm top
600126-10
Align the heim joint at right angles to the screws
Specification
Nut, A-arm top
Info
All four heim joints must be checked and adjusted if necessary.
Remove the vehicle from the work stand. (
600128-10
P. 31)
.
with bushings
.
in the heim joint and clip onto the A-arm.
is not aligned with the top edge of the A-arm:
with the heim joint in steps of 180° until the marking is in
.
. Mount and tighten screws
M10x52
M12x1,25
.
45 Nm
(33.2 lbf ft)
and tighten the nut
30 Nm
(22.1 lbf ft)
P. 31)
40
.