Light Switch; Eng. Stop Switch; Electric Starter Button; Ignition Switch - KTM 525 XC ATV 2008 Owner's Manual

OPERATING ELEMENTS

Light switch

ENG. STOP Switch

Electric starter button

Ignition switch

Indicator lamp overview

The light switch
Possible states
• High beam on HI
and the tail light are switched on.
• Low beam on LO
beam and tail lights are switched on.
• Lights off OFF
are switched off.
100011-10
The ENG. STOP switch
Possible states
• Ignition off OFF
engine stops, and the engine cannot be started.
• Ignition on RUN
be started.
100030-10
The START electric starter button is fitted on the left side of the handlebar.
Possible states
• Electric starter button in basic position
• Electric starter button pressed
100029-10
The ignition switch
Possible states
Ignition off
engine stops, and a non-running engine will not start.
Ignition on
can be started.
100031-10
Possible states
Reverse gear indicator lamp
Ignition indicator lamp
High beam indicator lamp
Idle speed indicator lamp
to idle.
400288-10
is fitted on the left side of the handlebar.
Light switch is turned upwards. In this position, the high beam
Light switch is at the middle setting. In this position, the low
Light switch has been swiveled down. In this position, all lights
is fitted on the left side of the handlebar.
In this position, the ignition circuit is interrupted, a running
In this position, the ignition circuit is closed and the engine can
In this position, the electric starter is actuated.
is located on the instrument support.
In this position, the ignition circuit is interrupted, a running
In this position, the ignition circuit is closed and the engine
lights up red
lights up yellow
lights up blue
lights up green
15
Reverse gear is engaged.
Ignition is switched on.
High beam is switched on.
Transmission is switched