Drive Chain Slider - Honda CB UNICORN DAZZLER 2010 Owner's Manual

Lubrication and Cleaning:
Lubricate every 1,000 km (600 miles) or
sooner if chain appears dry.
The drive chain on this motorcycle is
equipped with small O-rings between the
link plates. These O-rings retain grease
inside the chain to improve its service life.
The O-rings in this chain can be damaged
by steam cleaning, high pressure washers,
and certain solvents. Clean the side surfaces
of the chain with a dry cloth. Do not brush
the rubber O-rings. Brushing will damage
them. Wipe dry and lubricate only with SAE
80 or 90 gear oil. Commercial chain
lubricants may contain solvents which could
damage the rubber O-rings.
Repalcement chain:R428NOR-126
NOTICE
However for lubrication and cleaning, please
contact Honda authorized service center.

DRIVE CHAIN SLIDER

Refer to the Safety Precautions on page 40.
Check the chain slider (1) for wear.
The chain slider must be replaced if it is
worn to the wear limit cutout (2). For
replacement, see your Honda dealer.
(1) Chain slider
¼pS u LykbZ M j½
(2) Wear limit cutout ¼fo;j fyfeV dVvkmV½
(2)
61