Fuel Line Inspection - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Ground the White/blue wire terminal of the wire
harness side connector with a jumper wire.
TOOL:
Test probe
Turn the ignition switch to "ON", the MIL should
come on.
– If the MIL comes on, replace the ECM with a new
one and recheck the MIL indication.
Refer to Key Registration Procedures (page 21-6)
– If the MIL does not come on, check for open cir-
cuit in the White/blue wire between the combina-
tion meter and ECM.
If the wire is OK, replace the combination meter
(page 20-15).

FUEL LINE INSPECTION

FUEL PRESSURE RELIEVING/QUICK
CONNECT FITTING REMOVAL
• Before disconnecting fuel feed hose, relieve pres-
sure from the system as following procedures.
1. Turn the ignition switch OFF.
Lift and support the fuel tank (page 3-5).
2. Disconnect the fuel pump 2P (Black) connector.
3. Start the engine, and let it idle until the engine
stalls.
4. Turn the ignition switch OFF.
5. Disconnect the battery negative (–) cable (page
17-5).
6. Check the fuel quick connect fitting for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
email: info@motomatrix.co.uk
White/blue
(A20)
07ZAJ-RDJA110
FUEL SYSTEM (PGM-FI)
ECM 33P (Black) CONNECTOR A
(Wire side/female terminal)
2P (Black) CONNECTOR
QUICK CONNECT FITTING
5-51