Suzuki SY413 Service Manual page 2615

6-1-16 ENGINE GENERAL INFORMATION AND DIAGNOSIS (G13/G16 ENGINE WITH WU TWC)
(3 A/T: Refer to Section 7B for DIAGNOSIS)
DTC NO. DETECTING ITEM
Transmission range sensor
P0705
(switch) circuit malfunction (A/T)
Output speed sensor circuit
P0720
malfunction (A/T)
Shift solenoid A (#1) performance
P0751
or stuck off
Shift solenoid B (#2) performance
P0756
or stuck off
Shift solenoid A (#1) electrical
P0753
(A/T)
Shift solenoid B (#2) electrical
P0758
(A/T)
(4 A/T: Refer to Section 7B1 for DIAGNOSIS)
DTC NO. DETECTING ITEM
Transmission range sensor
P0705
(switch) circuit malfunction
A/T fluid temp. sensor circuit
P0710
malfunction
Input speed sensor circuit
P0715
malfunction
Output speed sensor circuit
P0720
malfunction
Engine speed input circuit
P0725
malfunction
Pressure control solenoid
P0745
malfunction
Shift solenoid A (#1) performance
P0751
or stuck off
P0753 Shift solenoid A (#1) electrical
Shift solenoid B (#2) performance
P0756
or stuck off
P0758 Shift solenoid B (#2) electrical
TCC solenoid performance or
P0741
stuck off
P0743 TCC solenoid electrical
Throttle position signal input
P1700
malfunction
Internal control module check sum
P1702
error
Engine coolant temp. signal input
P1705
malfunction
TCM to ECM torque reduction
P1895
circuit malfunction
DETECTING CONDITION
(DTC will set when detecting:)
No signal or multiple signals inputted with shifted in
"D" range
No signal while running vehicle with "D" or "2" range.
While running in "D" range, engine speed as
compared to vehicle speed is higher or lower than compared to vehicle speed is higher or lower than
specified value.
Output command from PCM and output voltage do
not agree. (solenoid circuit shorted to ground or not agree (solenoid circuit shorted to ground or
open)
DETECTING CONDITION
(DTC will set when detecting:)
Refer to Section 7B1.
MIL
1 driving
cycle
1 driving
cycle
2 driving g
cycles
1 driving g
cycle
MIL