Table of Contents
Advertisement
Windscreen
Before preparing the glass for installation, check there are no imperfections or scratches on the surface
or around the perimeter.
Set the glass panel carefully on a stable surface so that it is not scratched or damaged.
Degrease the perimeter of the glass with BETACLEAN 3300 cod. 81636500 and leave to dry.
If necessary, replace the two alignment blocks (1),
fitting the new parts in the original positions.
Check the expiry date of the PRIMER to ensure
that it is suitable for use.
Shake the can well, continuing for 30 seconds
after the ball bearings inside the can itself
can be heard to move.
Protect newly applied primer from draughts
during work breaks. Never exceed the
drying time of 8 hours.
Apply BETAPRIMER 5500, green cap, code
81636600 to the entire perimeter of the glass
between the two dotted lines in the figure and
leave the product to dry for at least 5 minutes.
The inner dotted line at the top and side of the
glass overlaps the solid screen-printed area by
approximately 10 mm.
Page 3 of 4
Advertisement
Table of Contents
