Omron FH-1 series User Manual page 507

Error message
Loading the startup Scene group failed. No
read location found. Try one of the following:
• When reading from an external storage
device, verify connection to the external
memory device and press OK button to do
load operation.
• To change the Startup scene group, select
Change startup scene.
• If there is no external storage device
attached, or no Startup scene group set,
in the Scene group saving destination set-
tings, select Save all scene group data in
the flash memory.
Warning range shall be set within the range
from judgement lower to upper limit.
The "Search" measurement result may be
"NG (Insufficient memory)" with the current
setting.
Save operation failed due to insufficient
flash memory space in the Sensor Control-
ler. The current Scene group data in Sensor
Controller memory will be discarded after
system reboot.
The problem occurred in the system.
The problem occurred in system date.
The system battery is insufficient.
Failed to switch scene.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
Troubleshooting
Here are some things to consider. Choose a remedy noting the
messages.
• No read location for the Scene group
• The external storage device containing the Scene group is cor-
rupted.
• The Scene group data is corrupted.
• You have selected a non-existing Scene group.
Moreover, when this error message is displayed even though
external storage has been connected, a recognition delay of exter-
nal storage happens at start-up of the Sensor Controller and load-
ing scene group data from the external storage may have failed.
Refer to 3-6-2 Device Information Storage Tool on page 3-35.
Please redefine the upper and lower warning range limits such
that they are within the range between the lower and upper evalu-
ation limits.
Refer to Trend Monitor-Judgement Conditions (Trend Monitor) in
the Vision System FH/FHV/FZ5 Series Processing Item Function
Reference Manual (Cat. No. Z341).
Insufficient memory may occur during measurement.
Reset the model parameters.
• [Search]
Refer to Search - Judgement is NG (Insufficient Memory) in the
Vision System FH/FHV/FZ5 Series Processing Item Function
Reference Manual (Cat. No. Z341).
• [Flexible search]
Refer to Flexible search - Judgement is NG (Insufficient Mem-
ory) in the Vision System FH/FHV/FZ5 Series Processing Item
Function Reference Manual (Cat. No. Z341).
• [Classification]
Refer to Classification - Judgement is NG (Insufficient Memory)
in the Vision System FH/FHV/FZ5 Series Processing Item Func-
tion Reference Manual (Cat. No. Z341).
• Increase the free memory space then re-try saving to the Sen-
sor Controller.
• Delete Scene, or Processing unit, or try adjusting the Measure-
ment region of the Processing unit, or the size of the registered
model.
• Set the Save destination for the Scene group data to be an
external storage device.
Refer to 7-5 Saving Scene Groups in External Storage [Scene
Group Saving Destination Settings] on page 7-10.
• Save the current Scene group data to external storage.
Refer to 9-3 Saving Setting Data to the Controller RAMDisk or
an External Storage Device on page 9-8.
This is displayed when the significant abnormality occurs in the
controller system. Please contact one of our branches or regional
offices.
Low battery (for the backup of date and time data) level.
The batteries need to be replaced.
Please return old batteries to one of our branches or regional
offices.
Is a USBDisk set to the controller?
A USBDisk is needed to read scenes after scene group 1.
11 What to Do!
11
11 - 3