Omron FH-1 series User Manual page 502

10 Advanced Usage
Position measurement processing
Vision Master Calibration processing
• Using the Flow
The motionless workpiece (or a saved image) is continuously measured until the calibration is
completed.
This allows you to easily verify the operation of the calibration flow with the FH/FHV/FZ5-series
Controller. Conventionally, you could not verity the calibration flow unless the Controller was inte-
grated into the system.
Refer to Machine Simulator of the Vision System FH/FHV/FZ5 Series Processing Item Function Ref-
erence Manual (Cat. No. Z341).
10 - 66
↓
· · · Measure the position of the alignment marks or the position of
item
↓
· · · Set the machine setting processing item to reference, and then
item
a special feature of the workpiece from the image in Camera 1.
To output the position on the image, set [Calibration] on the
[Output parameter] tab page to OFF.
Out of the general measurement processing items (Inspections
and Measurements), you can use processing items with mea-
surement results that have an X and Y in the calculation
strings.
set the sampling.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)