Omron FH-1 series User Manual page 463

 Non-Multi-input + Parallel processing OFF
STEP1
↓
1 2
STEP
READY
BUSY
Input image
2.Camera
Image Input FH
Sensor
Controller
Processing
1.Multi-trigger Imaging Task block
After checking if READY is ON and BUSY is OFF, turn ON the STEP (STEP1).
1. When STEP turns ON, READY turns OFF and BUSY turns ON.
Camera image Input (2 Camera image input FH) is executed.
2. After READY turns OFF and BUSY turns ON, turn OFF the STEP.
Since both Multi-input mode and Parallel processing are disabled, measurement processing (3 Search) is
3.
executed after Camera Image Input without turning ON the READY.
After measurement processing (3. Search) is completed, READY turns ON. (The READY remains OFF
4.
until the "1 Multi-trigger Imaging" Task block is completed).
After checking if READY is ON, turn ON the STEP (STEP2).
When STEP turns ON, READY turns OFF.
5.
Since Non-Multi-input mode is selected, processing starts with camera settings for "5 Camera Image
Input".
6. After READY turns OFF, turn OFF the STEP.
Since both Multi-input mode and Parallel processing are disabled, measurement processing (6 Search) is
7.
executed after Camera Image Input without turning ON the READY.
After measurement processing (6. Search) is completed, READY turns ON. (The READY remains OFF
until the "4 Multi-trigger Imaging" Task block is completed).
8.
8 Calculation that comes after Multi-trigger Imaging End is performed.
After Multi-trigger Imaging End measurement processing is completed, BUSY turns OFF.
9.
Display processing (11 Result Display) is performed.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
STEP2
↓
3 4 5 6
Camera
Input image
settings
5.Camera
Image Input FH
Measurement
processing
3.Search
4.Multi-trigger Imaging Task block
10 Advanced Usage
7 8
Measurement Measurement
Measurement processing
processing processing
8.Calculation 9.Conditional
6.Search
Branching
9
Measurement Display
processing
processing
11.Result
10.Search
Display
10 - 27
10