6
Select your target Sensor Controller in the list and click [Set Network].
7
Set the IP address for the Sensor Controller on the "Network setting".
8
Click [OK].
The IP address is set to the Sensor Controller.
9
On the network reference list, click [Refresh] to check the IP address setting is reflected.
Precautions for Correct Use
The reflection of IP address settings may take time. If it were not reflected, click [Refresh]
again.
Precautions for Correct Use
If a bad IP address or an IP address overlapped with a device on the same network are set, an
IP address different from your Setting will be displayed on the list like (169.254. xx. xx). Perform
this procedure to set a valid IP address.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
10 Advanced Usage
10 - 9
10