Omron FH-1 series User Manual page 411

Phenomenon
An error message occurred
because loading of the
Sensor Controller's project
failed.
"File writing failed."
An error message occurred
because loading of the
Sensor Controller's project
failed.
"File destination does not
exist."
Change screen of the save
destination setting for
Scene grope is displayed.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
Cause
Insufficient free memory in Sen-
sor Controller
External storage is not plugged
in.
Sensor Controller's project files
is corrupted.
A Sensor Controller project
saved by FH series/FZ5-800/
1100/1200 series is loaded by
FZ5-L series/FZ5-600 series.
External storage is not plugged
in.
Drive name of external storage
differs from the Sensor Control-
ler project.
A Sensor Controller project
saved by FH series/FZ5-800/
1100/1200 series is loaded by
FZ5-L series/FZ5-600 series.
Model type is different from
saved Sensor Controller and
loading one.
Connected storage configuration
differs.
9 Saving/Loading Data
Action
Resave to the Sensor Controller after increas-
ing free memory space by deleting Scenes, or
Processing units, adjusting the measurement
region of Processing unit, or registered model
size.
Plug in the external storage.
• Power was possibly turned off during last
save operation.
• Insufficient memory can occur due to
increased memory requirement for current
Operation mode.
Save destination of Scene group can differ if the
created environment and loading environment
are different.
Set the save destination.
Plug in the external storage.
Set the save destination.
Save destination of Scene grope can differ if the
created environment and loading environment
are different.
Set the save destination.
Save destination of Scene grope can differ.
Reset the save destination.
9
9 - 31