Omron FH-1 series User Manual page 126

4 Setting the Controller
OK: Supported processing item, RST: Processing item with restricted support, ---: Unsupported processing item
Processing item
Intersection
Barcode
Glue Bead Inspection
Position Compensation
Filtering
*1. The [Subt./Reg.] and [DI Register] measurement modes are not supported.
*2. Sensor Controller in Non-Stop Adjustment Mode does not stand by.
*3. Re-measured images in Non-Stop Adjustment Mode are logged.
Standard (Operation Mode)
Normally, the sensor controller executes measurements, image logging, and image display in a desig-
nated order. The FH series/FZ5-800/1100/1200 series execute those processes with one of the CPU
cores, and uses the rest of the cores for measurement processing. This ensures that measurements
are always processed at maximum performance.
4 - 28
Sup-
Processing item
port
OK Position Data Calculation
OK Stage Data
OK Robot Data
OK Vision Master Calibration
OK PLC Master Calibration
Sup-
Processing item
port
OK Manual Position Setting
OK 2DCode II
OK Result output (I / O)
--- Result output (Message)
---
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
Sup-
port
---
OK
OK
OK