Omron FH-1 series User Manual page 120

4 Setting the Controller
Item
Communi- EtherNet/IP
cations
STEP setting
Communi- EtherCAT
cations
4 - 22
FH series:
FH-1000/3000/5000 series
• To use EtherNet/IP, use an EDS file
that matches the line to be used.
• Specify different I/O memory
addresses for the sending area and
receiving area for line 0 and for lines
1 to 7.
The value of the STEP signal filter for
the most recently set line is applied to
all lines.
• The Communications Module is set
for each line.
• The communications settings can be
set only for line 0.
The settings are applied as shown
below.
[Output control]: The same setting is
used for all lines.
[Output period]: The same setting is
used for all lines.
[Output setting]: This is set for each
line.
• The I/O ports (areas) for communica-
tions between the FH series Sensor
Controller and master are assigned as
shown below.
I/O ports for the Command Area: I/O
ports are assigned for each line.
I/O ports for the Response Area: I/O
ports are assigned for each line.
I/O ports for the Output Area: I/O
ports are assigned for each line.
The I/O ports in the Sysmac Error
Status Area are shared by all lines.
• The maximum data size that can be
output depends on the number of
lines, as shown in the following table.
1 to 5 lines: 256 bytes max.
6 to 8 lines: 128 bytes max.
FZ5 series:
FZ5-800/1100/1200 series
• To use EtherNet/IP, use an EDS file that
matches the line to be used.
• Specify different I/O memory addresses
for the sending area and receiving area
for line 0 and for line 1.
The value of the STEP signal filter for
each line is applied to each line.
Vision System FH/FHV/FZ5 Series User's Manual (Z365)
---