Omron FH-1 series User Manual page 150

4 Setting the Controller
3
Set the advanced settings for the trigger as necessary.
Parameter
Trigger signal
Phase A
Enable timing
Pulse reset timing • [Every trigger pulse]
Phase A trigger
Support backlash-
ing (using phase
B)
Trigger in back-
lashing
Phase Z
Enable timing
Pulse reset timing • [Every trigger pulse]
Phase Z trigger
Important
The encoder trigger setting is disabled for the FZ5-L series.
4 - 52
Set value
[Factory default]
[Phase A] Set the phase to use as the trigger signal.
Phase Z
• [ENABLE start] Set the timing for starting the pulse count.
• STEP start
ENABLE start: Counts the pulses input during the measurement
trigger receipt period.
STEP start: The pulses are not counted even during the mea-
surement trigger receipt period until the STEP signal is input.
Set the timing for resetting. When [ENABLE start] is specified for
[Enable timing], you can select [Every trigger pulse] or [Every
• Every rotation
rotation (Pulse Z)]. When [STEP start] is specified for [Enable
(Pulse Z)
timing], you can select [Every trigger pulse] or [Every STEP].
• Every STEP
When [Every rotation] is set, multiple pulses can be set for
phase A.
[0] to 65535 Set how many pulses it takes to produce a trigger.
• Checked Set whether the rotation direction is detected.
• [Unchecked]
• Checked Set to produce a trigger during reverse rotation.
• [Unchecked]
• [ENABLE start] Set the timing for starting the pulse count.
• STEP start
ENABLE start: Counts the pulses input during the measurement
trigger receipt period.
STEP start: The pulses are not counted even during the mea-
surement trigger receipt period until the STEP signal is input.
Set the timing for resetting the pulse count of phase Z.
Every trigger pulse: Reset the pulse count of phase Z each time
the Sensor Controller outputs a trigger.
[1] to 1023 Set how many pulses it takes to produce a trigger.
Description
Vision System FH/FHV/FZ5 Series User's Manual (Z365)