Test Channel Output - Teledyne T101 Operation Manual

Operating Instructions

4.6.9. TEST CHANNEL OUTPUT

SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
DIAG SIGNAL I / O
NEXT
DIAG ANALOG OUTPUT
PREV NEXT
Table 4-15. Test Parameters Available for Analog Output A4
102
When activated, output channel A4 can be used to report one of the test functions
viewable from the SAMPLE mode display. To activate the A4 channel and select a test
function, follow this button sequence:
H2S =XXX.X
SETUP
ENTR EXIT
MORE EXIT
EXIT
ENTR EXIT
ENTR EXIT
TEST CHANNEL
NONE
PMT READING
UV READING
SAMPLE PRESSURE
SAMPLE FLOW
RCELL TEMP
CHASSIS TEMP
IZS TEMP
PMT TEMP
CHASSIS TEMP
HVPS VOLTAGE
1
This refers to the voltage range of the parameter and
not the output signal of the test channel.
Teledyne ML – T101 Operation Manual
DIAG
EXIT returns
to the main
PREV
SAMPLE
display
DIAG TCHN
DIAG TCHN
PREV
Press PREV or NEXT
to move through the
list of available
parameters
(Table 6-13)
TEST PARAMETER RANGE
Test channel is turned off
0-5000 mV
0-5000 mV
0-40 in-Hg-A
0-1000 cm³/min
0-70° C
0-70° C
0-70° C
0-50° C
0-70° C
0-5000 V
Continue to press NEXT until ...
TEST CHAN OUTPUT
NEXT ENTR
TEST CHANNEL: NONE
NEXT ENTR
TEST CHANNEL: PMT READING
NEXT ENTR
Press ENTR to select
the displayed
parameter activating
the test channel.
1
EXIT
EXIT
EXIT
Press EXIT to
return to the
DIAG menu