Setup - Cfg: Viewing The Analyzer'sconfiguration Information - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual
If the analyzer beeps when you press the EXIT button, it means that you've made a
change/entered a new value for a parameter but have not caused it to be accepted by
4.4.1. SETUP – CFG: VIEWING THE ANALYZER'S
CONFIGURATION INFORMATION
Press NEXT of PREV to move back
and forth through the following list
of Configuration information:
• MODEL NAME
• SERIAL NUMBER
• SOFTWARE REVISION
• LIBRARY REVISION
• iCHIP SOFTWARE REVISION
• HESSEN PROTOCOL REVISION
• ACTIVE SPECIAL SOFTWARE
OPTIONS 1
• CPU TYPE
• DATE FACTORY CONFIGURATION
SAVED
1
Only appears if relevant option of Feature is active.
pressing ENTR first.
Pressing the CFG button displays the instrument configuration information. This display
lists the analyzer model, serial number, firmware revision, software library revision, CPU
type and other information. Use this information to identify the software and hardware
when contacting Technical Support. Special instrument or software features or installed
options may also be listed here.
SAMPLE*
< TST TST > CAL
SAMPLE
8
SAMPLE
CFG DAS RNGE PASS CLK MORE
1
1
SAMPLE
NEXT
NOTE
RANGE = 500.0 PPB
ENTER SETUP PASS : 818
1 8
PRIMARY SETUP MENU
T101 SO2-H2S ANALYZER
PREV
Operating Instructions
H2S =X.XXX
SETUP
ENTR EXIT
Press EXIT at
any time to
return to the
EXIT
SAMPLE display
Press EXIT at
any time to
return to
EXIT
SETUP menu
65