Editing Das Parameters - Teledyne T101 Operation Manual

Operating Instructions

4.8.2.4. Editing DAS Parameters

YES will delete
all data in that
entire channel.
Moves the
display between
available
Parameters
Inserts a new Parameter
before the currently
displayed Parameter
134
Data channels can be edited individually from the front panel without affecting other data
channels. However, when editing a data channel, such as during adding, deleting or
editing parameters, all data for that particular channel will be lost, because the DAS can
store only data of one format (number of parameter columns etc.) for any given channel.
In addition, an DAS configuration can only be uploaded remotely as an entire set of
channels. Hence, remote update of the DAS will always delete all current channels and
stored data.
To modify, add or delete a parameter, follow the instruction shown in Section 4.11.2.2
then press:
From the DATA ACQUISITION menu
Edit Data Channel Menu
SETUP X.X 0) CONC:
PREV NEXT
SETUP X.X NAME:CONC
<SET SET> EDIT
Press SET> until...
SETUP X.X PARAMETERS : 2
<SET SET> EDIT
SETUP X.X EDIT PARAMS (DELETE DATA)
YES NO
SETUP X.X 0) PARAM=S2SCN1, MODE=AVG
PREV NEXT
Deletes the Parameter
currently displayed.
ATIMER, 2,
INS DEL EDIT PRNT
PRINT
PRINT
Edit Data Parameter Menu
INS DEL EDIT
Teledyne ML – T101 Operation Manual
4032, R
Exits to the main
Data Acquisition
EXIT
EXIT
EXIT
NO returns to
the previous
menu and
retains all data.
Exits to the main
Data Acquisition
EXIT
Use to configure
the functions for
this Parameter.
menu
menu