Teledyne T101 Operation Manual page 112

Operating Instructions
It is a good idea to check these settings the first time you power up your analyzer after it has been
physically connected to the LAN/Internet to make sure that the DHCP has successfully downloaded the
If the gateway IP, instrument IP and the subnet mask are all zeroes (e.g. "0.0.0.0"), the DCHP was not
You may have to manually configure the analyzer's Ethernet properties.
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
COMMUNICATIONS MENU
SETUP X.X
ID INET COM1 COM2
108
will automatically be assigned an IP address by the DHCP server (Section 4.10.6.2). This
configuration is useful for quickly getting an instrument up and running on a network.
However, for permanent Ethernet connections, a static IP address should be used. Section
4.7.6.2 below details how to configure the instrument with a static IP address.
appropriate information from you network server(s).
See your network administrator.
To view the LAN/Internet default configuration properties, press:
H2S =XXX.X
SETUP
ENTR EXIT
MORE EXIT
EXIT
EXIT
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
Teledyne ML – T101 Operation Manual
NOTE
successful.
DHCP: ON
SETUP X.X
SET> EDIT
INST IP: 0.0.0.0
SETUP X.X
<SET SET>
GATEWAY IP: 0.0.0.0
SETUP X.X
<SET SET>
SUBNET MASK: 0.0.0.0
SETUP X.X
<SET SET>
TCP PORT: 3000
SETUP X.X
<SET SET> EDIT
HOSTNAME: T101
SETUP X.X
<SET EDIT
EXIT
EXIT
EDITING
disabled
when
DHCP is
EXIT
ON
EXIT
EXIT
Do not alter
unless
directed to by
Teledyne
API's
Customer
Service
EXIT
personnel