Teledyne T101 Operation Manual page 83

Teledyne ML – T101 Operation Manual
SAMPLE
< TST TST > CAL
SAMPLE
8
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM VARS
SETUP X.X
SETUP X.X
SETUP X.X
PREV NEXT
SETUP X.X
PREV
SETUP X.X
PREV
SETUP X.X
PREV NEXT
SETUP X.X
PREV NEXT
SETUP X.X
PREV
SETUP X.X
PREV
To access and navigate the VARS menu, use the following touchscreen button sequence:
RANGE = 500.0 PPB H2S =XXX.X
ENTER SETUP PASS : 818
1 8 ENTR
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
DIAG EXIT
0 ) MEASURE_MODE=H2S
NEXT JUMP EDIT PRNT EXIT
1 ) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP EDIT PRNT EXIT
1 ) TPC_ENABLE=ON
JUMP EDIT PRNT EXIT
3)RCELL_SET=50.0 DegC
NEXT JUMP EDIT PRNT EXIT
3) IZS_SET=50.0 DegC
NEXT JUMP EDIT PRNT EXIT
5 ) DYN_ZERO=ON
JUMP EDIT PRNT EXIT
6) DYN_SPAN=ON
JUMP EDIT PRNT EXIT
7) CONC_PRECISION : 1
NEXT JUMP EDIT PRNT EXIT
8) CLOCK_ADJ=0 Sec/Day
NEXT JUMP EDIT PRNT EXIT
SETUP
EXIT
EXIT
EXIT ignores the new setting.
ENTR accepts the new setting.
See Section 6.8.1
for instructions
regarding this setting
SETUP X.X DAS_HOLD_OFF=15.0 Minutes
1 5 .0
SETUP X.X TPC_ENABLE=ON
ON
DO NOT change
theses set-points
instructed to by
T-API Customer
SETUP X.X DYN_ZERO=ON
ON
SETUP X.X DYN_SPAN=ON
ON
SETUP X.X CONC_PRECISION : 3
AUTO 0 1
SETUP X.X CLOCK_ADJ=0 Sec/Day
+ 0 0
Operating Instructions
ENTR EXIT
Toggle to change setting
ENTR EXIT
Toggle to change setting
unless
specifically
Service.
ENTR EXIT
Toggle to change setting
ENTR EXIT
Toggle to change setting
2 3 4 ENTR EXIT
Toggle each to change settings
ENTR EXIT
Toggle each to change setting
79