Initial Calibration; Basic Calibration Procedure - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual

3.6. INITIAL CALIBRATION

3.6.1. BASIC CALIBRATION PROCEDURE

Press this button to set
the analyzer for SNGL
DUAL or AUTO ranges
To change the value of the reporting
range span, enter the number by
pressing the button under each digit
until the expected value appears.
The following three-step procedure assumes that the instrument does not have any of the
available zero/span (Z/S) or IZS valve options installed. Section 6 contains instructions
for calibrating instruments with valve options.
The initial calibration should be carried out with the analyzer's reporting range for
SINGLE range mode with a range span of 500 PPB (factory default settings for most
units). This will enable you to compare your results to the factory calibration.
STEP ONE: Set/verify the analog output reporting range of the T101:
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1
SETUP X.X
CFG DAS RNGE
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X
0 0 5
SETUP X.X
0 0 0
H2S =XXX.X
SETUP
8 ENTR EXIT
PASS CLK MORE EXIT
EXIT
RANGE: 500.0 CONC
0 0 .0 ENTR EXIT
RANGE: 500.0 Conc
5 0 .0 ENTR EXIT
Getting Started
Press this button to select the
concentration units of measure:
PPB, PPM, UGM, MGM
EXIT ignores the new setting and
returns to the RANGE CONTROL
MENU.
ENTR accepts the new setting and
returns to the
RANGE CONTROL MENU.
53