Editing Das Data Channels - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual

4.8.2.2. Editing DAS Data Channels

EXIT will return to the
previous SAMPLE
display.
Moves the
display up &
down the list of
Data Channels
Inserts a new Data
Channel into the list
BEFORE the Channel
currently being displayed
Moves the display
between the
properties for this data
channel.
To edit the channel name, see next sequence.
DAS configuration is most conveniently done through the APICOM remote control
program. The following list of key strokes shows how to edit using the front panel.
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE
Main Data Acquisition Menu
SETUP X.X DATA ACQUISITION
VIEW EDIT
SETUP X.X 0) CONC:
PREV NEXT
Deletes The Data
Channel currently
being displayed
SETUP X.X NAME:CONC
<SET SET> EDIT PRNT
When editing the data channels, the top line of the display indicates some of the
configuration parameters. For example, the display line:
0) CONC: ATIMER, 4, 800
translates to the following configuration:
Channel No.: 0
NAME: CONC
TRIGGER EVENT: ATIMER
H2S =XXX.X
SETUP
ENTR EXIT
EXIT
EXIT
Edit Data Channel Menu
ATIMER, 2, 4032, R
INS DEL EDIT PRNT EXIT
EXIT
Reports the configuration of current
data channels to the RS-232 ports.
Operating Instructions
Exits to the Main
Data Acquisition
Menu
Exports the
configuration of all
data channels to
RS-232 interface.
EXIT returns to the
previous Menu
131