Teledyne T101 Operation Manual page 165

Teledyne ML – T101 Operation Manual
<CH and CH> k
move the [ ]
cursor left and
right along the
bit string.
To assign or reset the status flag bit assignments, press:
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1
Repeat pressing SET> until ...
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT
Repeat pressing NEXT or PREV until the desired
message flag is displayed. See Table 6-27.
SETUP X. SYSTEM RESET: 0000
PREV NEXT
SETUP X. SYSTEM RESET: [0]000
<CH CH>
Press [?] repeatedly to cycle through the available character set: 0-9
(Some alpha characters may also be available but are meaningless).
H2S =XXX.X
SETUP
ENTR EXIT
MORE EXIT
ALRM EXIT
COM2 EXIT
EXIT
EDIT PRNT EXIT
For example ...
EDIT PRNT EXIT
[0] ENTR EXIT
Remote Operation
ENTR accepts the new
settings
EXIT ignores the new
settings
161