Help Commands In Terminal Mode - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual

5.1.2.2. Help Commands in Terminal Mode

Table 5-3. Terminal Mode Software Commands
COMMAND
Control-T
Control-C
CR
(carriage return)
BS
(backspace)
ESC
(escape)
? [ID] CR
Control-C
Control-P
Function
Switches the analyzer to terminal mode (echo, edit). If mode flags 1 & 2 are OFF,
the interface can be used in interactive mode with a terminal emulation program.
Switches the analyzer to computer mode (no echo, no edit).
A carriage return is required after each command line is typed into the
terminal/computer. The command will not be sent to the analyzer to be executed
until this is done. On personal computers, this is achieved by pressing the ENTER
key.
Erases one character to the left of the cursor location.
Erases the entire command line.
This command prints a complete list of available commands along with the
definitions of their functionality to the display device of the terminal or computer
being used. The ID number of the analyzer is only necessary if multiple analyzers
are on the same communications line, such as the multi-drop setup.
Pauses the listing of commands.
Restarts the listing of commands.
Remote Operation
147