Teledyne T101 Operation Manual page 25

Teledyne ML – T101 Operation Manual
Option
Option
Number
Current Loop Analog
Outputs
41
Parts Kits
42A
43
45
NO Optical Filter
47B
Calibration Valves
50A
50G
H S Permeation Tubes
2
(uncertified) 52A
(certified) 52E
Communication Cables
60A
60B
60C
60D
Concentration Alarm
Relay
61
RS-232 Multidrop
62
Special Features
N/A
Adds isolated, voltage-to-current conversion circuitry to the
analyzer's analog outputs.
Isolated 0-20 or 4-20 mA current output (up to three can be retrofitted if not
installed at the factory)
Expendables Kit with IZS includes the items needed to refurbish the
internal zero air scrubber (IZS) that is included.
Spare Parts Kit includes spares parts for one unit.
Recommended for High NOX backgrounds.
Required for EN Certification.
Used to control the flow of calibration gases generated from external
sources, rather than manually switching the rear panel pneumatic
connections.
Ambient Zero and Ambient Span
Zero Scrubber and Internal Span Source (IZS)
Replacement tubes for the IZS option; identical size/shape; different
effusion rates.
Effusion Rate
Approximate
Concentration
(@ 50°C)
106 ng/min .08 -.12 ppm
76 ng/min .04 - .06 ppm
For remote serial, network and Internet communication with the
analyzer.
Type Description
Shielded, straight-through DB-9F to DB-25M cable, about 1.8 m
RS-232 long. Used to interface with older computers or code activated
switches with DB-25 serial connectors.
Shielded, straight-through DB-9F to DB-9F cable of about 1.8 m
RS-232
length.
Patch cable, 2 meters long, used for Internet and LAN
Ethernet
communications.
Cable for direct connection between instrument (rear panel USB
USB
port) and personal computer.
Issues warning when gas concentration exceeds limits set by user.
Four (4) "dry contact" relays on the rear panel of the instrument. This relay
option is different from and in addition to the "Contact Closures" that come
standard on all TML instruments.
Enables communications between host computer and up to eight
analyzers.
Multidrop card seated on the analyzer's CPU card.
Each instrument in the multidrop network requires this card and a
communications cable (Option 60B).
Built in features, software activated
Maintenance Mode Switch, located inside the instrument, places the
Description/Notes
Specified Flow Rate (of indicated perm
tube rate)
0.76 lpm (nominal) ± 25%
0.76 lpm ± 5%
Introduction
21