Teledyne T101 Operation Manual page 119

Teledyne ML – T101 Operation Manual
USB configuration requires that the baud rates of the instrument and the PC match; check the PC baud
Using the USB port disallows use of the rear panel COM2 port except for multidrop communication.
5. In the instrument's SETUP>MORE>COMM>COM2 menu, make the following settings:
Baud Rate: 115200
COM2 Mode Settings:
Quiet Mode
Computer Mode
MODBUS RTU
MODBUS ASCII
E,8,1 MODE
E,7,1 MODE
RS-485 MODE
SECURITY MODE
MULTIDROP MODE
ENABLE MODEM
ERROR CHECKING
XON/XOFF HANDSHAKE
HARDWARE HANDSHAKE OFF
HARDWARE FIFO
COMMAND PROMPT
6. Next, configure your communications software, such as APICOM. Use the COM port
determined in Step 4 and the baud rate set in Step 5.
these parameters would be configured in the Instrument Properties window in
APICOM when configuring a new instrument. See the APICOM manual (PN 07463)
for more details.
rate and change if needed.
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
NOTE
Operating Instructions
The figures below show how
115