Hessen Protocol Gas Id - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual

5.1.4.6. Hessen Protocol Gas ID

SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG ALRM
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2
Press PREV & NEXT to cycle existing
entries in Hessen gas list
Press PREV & NEXT kto cycle
between the SO2 & H2S
Press PREV & NEXT to cycle
between the SO2 & H2S
Toggle to switch reporting Between
Since the T101 can be, when the proper optional equipment is installed and operating, a
multigas instrument that measures both H
Hessen protocol gas list. In its default state the Hessen protocol firmware assigns both
gases a Hessen ID number and actively reports both even if the instrument is only
measuring one.
To change or edit these settings press:
H2S =XXX.X
SETUP
ENTR EXIT
MORE EXIT
EXIT
EXIT
ON and OFF
S and SO
2
BUTTON FUNCTION
<PREV Moves to next gas entry in list
NEXT> Moves the cursor previous gas entry in list
INS
Inserts a new gas entry into the list.
DEL Deletes the >>>>>.
ENTR Accepts the new setting and returns to the previous menu.
EXIT Ignores the new setting and returns to the previous menu.
SETUP X.X HESSEN VARIATION: TYPE 1
SET> EDIT
SETUP X.X HESSEN RESPONSE MODE :CMD
<SET SET> EDIT
SETUP X.X HESSEN GAS LIST
<SET SET> EDIT
SETUP X.X SO2, 111, REPORTED
<PREV NEXT> INS DEL EDIT
SETUP X.X GAS TYPE SO2
<PREV NEXT>
SETUP X.X GAS ID: 111
0 0 0
SETUP X.X REPORTED : ON
ON
Remote Operation
, both of these gases are listed in the
2
EXIT
EXIT
EXIT
PRNT EXIT
ENTR EXIT
ENTR accepts the
new settings
EXIT ignores the
new settings
ENTR EXIT
ENTR EXIT
159