Autocal Of Instruments In Multigas Measurement Mode - Teledyne T101 Operation Manual

Calibration Procedures
6.9.2. AUTOCAL OF INSTRUMENTS IN MULTIGAS
MEASUREMENT MODE
Make sure that the gas for which the AutoCal sequence has been programmed is being
supplied to the analyzer at the time the autocal program initiates.
If the wrong gas is being supplied to the instrument, the analyzer will be mis-calibrated.
Follow standard AutoCal programming process to this
point, then ...
SETUP X.X CALIBRATE: ON
<SET SET> EDIT
SETUP X.X GAS-RANGE: H2S-HIGH
<SET EDIT
SETUP X.X GAS TO CAL: H2S
SO2 H2S
SETUP X.X Gas TO CAL: SO2
LOW HIGH
184
If the analyzer is being operated in multigas measurement mode, auto cal can only be
programmed to calibrate the instrument with one of the available gases.
If the instrument is in multigas measurement mode and the SNGL reporting range mode
is selected, the AutoCal sequence is programmed as described above. If the reporting
range of the T101 must is set for either IND or AUTO. the gas type and range to be
measured must be specified. This parameter appears at the end of the programming
sequences after the CALIBRATE: ON/OFF parameter is set. For example:
EXIT
EXIT
ENTR EXIT
ENTR EXIT
Teledyne ML – T101 Operation Manual
NOTE
SETUP X.X RANGE TO CAL: LOW
LOW HIGH
SETUP X.X RANGE TO CAL: HIGH
LOW HIGH
SETUP X.X GAS-RANGE: SO2-LOW
<SET EDIT
SETUP X.X SEQ 2) ZERO–SPAN, 2:00:30
PREV NEXT MODE SET
Sequence
MODE
ENTR EXIT
ENTR EXIT
EXIT
EXIT returns
to the SETUP
EXIT
Menu
Delta Time
Delta Days