Teledyne T101 Operation Manual page 307

Teledyne API T/E-Series Models 101, 102, and 108 Software Documentation (PN05492D DCN6485)
Setup Variable
FILT_DELTA
FILT_PCT
FILT_DELAY
FILT_ADAPT
DIL_FACTOR
USER_UNITS
LAMP_CAL
LAMP_GAIN
TEMPCO_GAIN
9
PMT_TARG_CONC
PMT_UPDATE_PERIOD
9
PMT_CAL_TIMEOUT
9
HVPS_ADJUST
9
HVPS_INTEG
9
HVPS_STABIL
9
PMT_ADJUST
SLOPE_CONST
DARK_ENABLE
DARK_FREQ
DARK_PRE_DWELL
DARK_POST_DWELL
07266B DCN6485
Numeric
Units
PPB
%
Seconds
—
—
—
mV
—
—
Conc
9
Seconds
Minutes
—
Gain
—
—
—
—
Minutes
Seconds
Seconds
Default Value Range
Value
20 1–100
5 1–100
180 0–300
ON OFF, ON
1 0.1–1000
PPB PPB,
PPM,
UGM,
MGM
3500 1000–5000
0.9 0.5–1.5
0.15 0.01–10
400 0.01–
9999.99
10 1–100
5 1–100
0 0–200
5 0–500
1 0.1–10
0 0–65535
8 0.1–10
ON, OFF, ON
9
OFF
30 0.1–1440
10 1–60
10 1–180
Description
Absolute change to trigger
adaptive filter.
Percent change to trigger
adaptive filter.
Delay before leaving
adaptive filter mode.
ON enables adaptive filter;
OFF disables it.
Dilution factor if dilution
enabled with FACTORY_OPT
variable.
Concentration units for user
interface. Enclose value in
double quotes (") when
setting from the RS-232
interface.
Last calibrated UV lamp
reading.
UV lamp compensation
attenuation factor.
Temperature coefficient
attenuation factor for
pressure readings.
Target SO concentration
2
during PMT calibration.
Period between HVPS gain
updates during PMT
calibration.
Maximum time for PMT
calibration to succeed.
HVPS gain adjustment.
Integral coefficient for
adjusting HVPS gain during
PMT calibration.
HVPS gain must stabilize to
within this limit for PMT
calibration to succeed.
PMT gain adjustment.
Constant to make visible
slope close to 1.
ON enables PMT/UV dark
calibration; OFF disables it.
Dark calibration period.
Dwell time after closing dark
shutter or turning off lamp
or selecting preamp range.
Dwell time after opening
dark shutter or turning on
lamp.
A-13