Warning Messages; Table 4-3. List Of Warning Messages - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual

4.2.2. WARNING MESSAGES

Table 4-3. List of Warning Messages

MESSAGE
ANALOG CAL WARNING
BOX TEMP WARNING
CANNOT DYN SPAN
CANNOT DYN ZERO
CONFIG INITIALIZED
CONV TEMP WARNING
DARK CAL WARNING
DATA INITIALIZED
HVPS WARNING
IZS TEMP WARNING
PMT DET WARNING
PMT TEMP WARNING
RCELL TEMP WARNING
REAR BOARD NOT DET
RELAY BOARD WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SYSTEM RESET
UV LAMP WARNING
The most common instrument failures will be reported as a warning on the analyzer's
front panel and through the COM ports. Section 9.1.1 explains how to use these messages
to troubleshoot problems. Table 4-3 lists the warning messages.
The instrument's A/D circuitry or one of its analog outputs is not
calibrated.
The temperature inside the T101 chassis is outside the specified
limits.
Remote span calibration failed while the dynamic span feature was
set to turned on
Remote zero calibration failed while the dynamic zero feature was
set to turned on
Configuration was reset to factory defaults or was erased.
The temperature of the H
its optimal operating range.
Dark offset above limit specified indicating that too much stray
light is present in the sample chamber.
DAS data storage was erased.
High voltage power supply for the PMT is outside of specified
limits.
On units with IZS options installed: The permeation tube
temperature is outside of specified limits.
PMT detector output outside of operational limits.
PMT temperature is outside of specified limits.
Sample chamber temperature is outside of specified limits.
The CPU is unable to communicate with the motherboard.
The firmware is unable to communicate with the relay board.
The flow rate of the sample gas is outside the specified limits.
Sample pressure outside of operational parameters.
The computer was rebooted.
The UV lamp intensity measured by the reference detector reading
too low or too high
MEANING
S  SO catalytic converter is outside
2 2
Operating Instructions
61