Appendix A-2: Setup Variables For Serial I/O, S/W Version C.7 (E-Series), 1.0.5 (T-Series) - Teledyne T101 Operation Manual

Teledyne API T/E-Series Models 101, 102, and 108 Software Documentation (PN05492D DCN6485)
APPENDIX A-2: Setup Variables For Serial I/O, S/W Version C.7 (E-Series), 1.0.5 (T-
Series)
Table A-1: Setup Variables
Setup Variable
MEASURE_MODE
CAL_GAS
DAS_HOLD_OFF
TPC_ENABLE
RCELL_SET
IZS_SET
DYN_ZERO
DYN_SPAN
07266B DCN6485
Numeric
Units
Low Access Level Setup Variables (818 password)
— SO2-H2S,
TRS
— DEF
Minutes 15
— ON
ºC 50
Warnings:
45–55
ºC 50
Warnings:
45–55
— OFF
— OFF
Default Value Range
Value
SO2,
6
H2S,
6
TRS ,
SO2-H2S,
6
SO2-TRS
6
H2S-TRS
SO2-H2S-
6
TRS ,
SO2-H2S-
REMOTE,
H2S-SO2-
REMOTE
DEF,
SO2,
H2S
0.5–20
OFF, ON
30–70
30–70
OFF, ON
OFF, ON
Description
Gas measurement mode.
Enclose value in double
quotes (") when setting from
the RS-232 interface.
,
,
Selects calibration gas (i.e.
valve position, as opposed to
slope/offset). DEF selects
default behavior, in which
valve position and
slope/offset are the same.
Enclose value in double
quotes (") when setting from
the RS-232 interface.
Duration of DAS hold off
period.
ON enables temperature and
pressure compensation; OFF
disables it.
Reaction cell temperature
set point and warning limits.
IZS temperature set point
and warning limits.
ON enables contact closure
dynamic zero; OFF disables
it.
ON enables contact closure
dynamic span; OFF disables
it.
A-11