Independent Range Mode (Ind) - Teledyne T101 Operation Manual

Operating Instructions

4.4.4.5. Independent Range Mode (IND)

SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK MORE
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X RANGE MODE:
SNGL IND AUTO
In INDEPENDENT range mode the two reporting ranges have separate slopes and offsets
for computing concentration and MUST be independently calibrated.
70
Selecting independent range mode allows the A1 and A2 outputs to be configured with
different measurement ranges. The analyzer software calls these two ranges LOW and
HIGH. The LOW range setting corresponds with the analog output labeled A1 on the
rear panel of the instrument. The HIGH range setting corresponds with the A2 output.
While the software names these two ranges LOW and HIGH, they do not have to be
configured that way.
Also, in this mode the RANGE Test function displayed on the front panel during
SAMPLE mode will be replaced by two separate functions, RANGE1 & RANGE2.
LOW range = RANGE1 = Range value for output A1 = 0-1500 ppb
•
H S.
2
HIGH range = RANGE2 = Range value for output A2 = 0-500 ppb
•
H S.
2
For T101's configured to measure both SO
LOW range = RANGE1 = Range value for output A1= 0-1500 ppm
•
SO .
2
HIGH range = RANGE2 = Range value for output A2 =0-1000 ppm
•
H S.
2
To select the independent reporting range mode and set the upper measurement limits for
the two outputs, press:
H2S =XXX.X
SETUP
ENTR EXIT
EXIT
EXIT
SNGL
ENTR EXIT
Teledyne ML – T101 Operation Manual
and H
2 2
SETUP X.X RANGE MODE:
SNGL IND AUTO
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X LOW RANGE: 500.0 Conc
0 0 1 0 0
SETUP X.X HIGH RANGE: 500.0 Conc
0 0 5 0 0
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
NOTE
S in multigas measurement mode:
DUAL
ENTR EXIT
EXIT
Toggle the
.0 ENTR EXIT
buttons under
each digit to set
the upper limit
of each range.
.0 ENTR EXIT
EXIT SAMPLE Display
EXIT Returns
to the Main