Teledyne T101 Operation Manual page 126

Operating Instructions
Select which COM
port to configure
The sum of the mode
IDs of the selected
modes is displayed
here
Use PREV and NEXT
keys to move between
available modes.
A mode is enabled by
toggling the ON/OFF
key.
122
Press the following buttons to select a communication mode for a one of the COMM
Ports, such as the following example where HESSEN PROTOCOL mode is enabled:
SAMPLE
< TST TST > CAL
SAMPLE
8 1
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM VARS DIAG
SETUP X.X
ID COM1
SETUP X.X
SET> EDIT
SETUP X.X
NEXT
Continue pressing next until ...
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON
Continue pressing the NEXT and PREV keys to select any other
modes you which to enable or disable
RANGE = 500.0 PPB H2S
ENTER SETUP PASS : 818
8 ENTR
PRIMARY SETUP MENU
MORE
SECONDARY SETUP MENU
ALRM
COMMUNICATIONS MENU
COM2
COM1 MODE:0
COM1 QUIET MODE: OFF
OFF ENTR EXIT
OFF ENTR EXIT
ENTR EXIT
Teledyne ML – T101 Operation Manual
=XXX.X
SETUP
EXIT
EXIT
EXIT returns
to the
previous
menu
EXIT
EXIT
EXIT
ENTR key accepts the
new settings
EXIT key ignores the
new settings