Figure 4-11. Default Das Channels Setup - Teledyne T101 Operation Manual

Teledyne ML – T101 Operation Manual
LIST OF CHANNELS
Sending an DAS configuration to the analyzer through its COM ports will replace the
existing configuration and will delete all stored data. Back up any existing data and the
NAME: CONC
EVENT: ATIMER
REPORT PERIOD: 000:00:05
NO. OF RECORDS: 4032
RS-232 REPORT: OFF
CHANNEL ENABLED: ON
CAL HOLD OFF: ON
NAME: PNUMTC
EVENT: ATIMER
REPORT PERIOD: 001:00:00
NO. OF RECORDS: 360
RS-232 REPORT: OFF
CHANNEL ENABLED: ON
CAL HOLD OFF: OFF
NAME: CALDAT
EVENT: SLPCHG
NO. OF RECORDS:200
RS-232 REPORT: OFF
CHANNEL ENABLED: ON
CAL HOLD OFF: OFF

Figure 4-11. Default DAS Channels Setup

These default Data Channels can be used as they are, or they can be customized from the
front panel to fit a specific application. They can also be deleted to make room for custom
user-programmed Data Channels.
Appendix A-5 lists the firmware-specific DAS configuration in plain-text format. This
text file can either be loaded into APICOM and then modified and uploaded to the
instrument or can be copied and pasted into a terminal program to be sent to the analyzer.
DAS configuration before uploading new settings.
LIST OF PARAMETERS
PARAMETER: S2CONC1
MODE: AVG
PRECISION: 1
STORE NUM SAMPLES OFF
PARAMETER: S2CONC1
MODE: AVG
PRECISION: 1
STORE NUM SAMPLES OFF
PARAMETER: SMPLFLW
MODE: AVG
PRECISION: 1
STORE NUM SAMPLES OFF
PARAMETER: SMPLPRS
MODE: AVG
PRECISION: 1
STORE NUM SAMPLES OFF
PARAMETER: S2SLP1
MODE: INST
PRECISION:3
STORE NUM SAMPLES OFF
PARAMETER: S2OFS1
MODE: INST
PRECISION: 1
STORE NUM SAMPLES OFF
PARAMETER: S2ZSC1
MODE: INST
PRECISION: 1
STORE NUM SAMPLES OFF
NOTE
Operating Instructions
129