Setup Mode; Table 4-4. Primary Setup Mode Features And Functions; Table 4-5. Secondary Setup Mode Features And Functions - Teledyne T101 Operation Manual

Operating Instructions

4.4. SETUP MODE

Table 4-4. Primary Setup Mode Features and Functions

MODE OR FEATURE
Analyzer Configuration
Auto Cal Feature
Internal Data Acquisition
system (DAS )
Analog Output Reporting
Range Configuration
Calibration Password
Security
Internal Clock
Configuration
Advanced SETUP
features

Table 4-5. Secondary Setup Mode Features and Functions

MODE OR FEATURE
External Communication
Channel Configuration
System Status Variables
System Diagnostic
Features
64
The SETUP mode allows you to configure the analyzer's hardware and software features,
perform diagnostic procedures, gather information on the instrument's performance and
configure or access data from the internal data acquisition system (DAS). For a visual
representation of the software menu trees, refer to Appendix A.
Pressing the SETUP button activates a prompt for a security password. The default
password is 818. Press ENTR to proceed.
However, there is the option to enable a higher level of security; described in Section
4.4.5.
Other password levels exist, allowing access to special diagnostic tools and variables used
only for specific and rarely needed troubleshooting and adjustment procedures. They
may be made available as needed by Teledyne ML's Technical Support department.
The following two tables decribe the menus under Setup mode:
TOUCHSCREEN
BUTTON
Lists key hardware and software configuration
CFG
information
Used to set up and operate the AutoCal feature.
ACAL
Only appears if the analyzer has one of the internal
valve options installed
Used to set up the DAS system and view recorded
DAS
data
Used to configure the output signals generated by
RNGE
the instrument's Analog outputs.
PASS Turns the calibration password feature ON/OFF
Used to Set or adjust the instrument's internal
CLK
clock
This button accesses the instrument's secondary
MORE
setup menu
TOUCHSCREEN
BUTTON
Used to set up and operate the analyzer's various
COMM
external I/O channels including RS-232; RS 485,
modem communication and/or Ethernet access.
Used to view various variables related to the
VARS
instrument's current operational status
Used to access a variety of functions that are used
DIAG
to configure, test or diagnose problems with a
variety of the analyzer's basic systems
Teledyne ML – T101 Operation Manual
DESCRIPTION
DESCRIPTION
MANUAL
SECTION
4.4.1
6.9
4.8
4.4.4
4.4.5
4.4.6
(Table
4-5)
MANUAL
SECTION
4.7 & 5
4.5
4.6