Connecting The Analog Outputs; Figure 3-7. Analog Output Connector; Table 3-3. Analog Input Pin Assignments - Teledyne T101 Operation Manual

Getting Started

3.3.2. CONNECTING THE ANALOG OUTPUTS

34

Table 3-3. Analog Input Pin Assignments

PIN DESCRIPTION
1 Analog input # 1
2 Analog input # 2
3 Analog input # 3
4 Analog input # 4
5 Analog input # 5
6 Analog input # 6
7 Analog input # 7
8 Analog input # 8
Analog input
GND
Ground
1
See Section 4.8 for details on setting up the
DAS.
Attach a strip chart recorder and/or data-logger to the appropriate contacts of the analog
output connecter on the rear panel of the analyzer.
ANALOG OUT
A1
+ - +

Figure 3-7. Analog Output Connector

The A1 and A2 channels output a signal that is proportional to the H
the sample gas.
The output, labeled A4 is special. It can be set by the user (Section 4.6.9) to output any
one of the parameters accessible through the <TST TST> buttons of the unit's Sample
display.
Pin-outs for the Analog Output connector at the rear panel of the instrument are presented
in Table 3-4.
Teledyne ML – T101 Operation Manual
DAS
PARAMETER
AIN 1
AIN 2
AIN 3
AIN 4
AIN 5
AIN 6
AIN 7
AIN 8
N/A
A2 A3 A4
- + - +
1
-
S concentration of
2