Activating Hessen Protocol - Teledyne T101 Operation Manual

Remote Operation

5.1.4.3. Activating Hessen Protocol

SAMPLE
Repeat the
entire process to
< TST TST > CAL
set up the
COM2 port
SAMPLE
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM
Select which COMM
SETUP X.X
port to configure
ID INET
EXIT
The sum of the mode
SETUP X.X
IDs of the selected
modes is displayed
here
156
The first step in configuring the T101 to operate over a Hessen protocol network is to
activate the Hessen mode for COMM ports and configure the communication parameters
for the port(s) appropriately. Press:
RANGE = 500.0 PPB H2S =XXX.X
SETUP
ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
PRIMARY SETUP MENU
MORE EXIT
SECONDARY SETUP MENU
VARS DIAG ALRM EXIT
COMMUNICATIONS MENU
COM1 COM2
COM1 MODE:0
SET> EDIT EXIT
Teledyne ML – T101 Operation Manual
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
Continue pressing next until ...
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: ON
PREV NEXT ON ENTR EXIT
Toggle OFF/ON to
change
activate/deactivate
selected mode.
ENTR accepts the new
settings
EXIT ignores the new
settings