Teledyne T101 Operation Manual page 312

Teledyne API T/E-Series Models 101, 102, and 108 Software Documentation (PN05492D DCN6485)
Setup Variable
REMOTE_CAL_MODE
HOLD_DAC_ON_CAL
PASS_ENABLE
RCELL_CYCLE
RCELL_PROP
RCELL_INTEG
RCELL_DERIV
IZS_CYCLE
IZS_PROP
IZS_INTEG
IZS_DERIV
HVPS_SET
MAX_PMT_DETECTOR
PHOTO_ABS_LIMITS
UV_LAMP_LIMITS
9
ELEC_TEST_LEVEL
9
OPTIC_TEST_LEVEL
A-18
Numeric Default
Units Value
— SO2-LOW
— OFF
— OFF
Seconds 2
1/ºC 0.3 (prop.
band = 3.3
ºC)
— 0.005
— 0.5
Seconds 2
1/ºC 1 (prop.
band = 1 ºC)
— 0.03
— 0
Volts 650
Warnings:
400–900
mV 4995
mV 450
Warnings:
125–625
mV 3500
Warnings:
1000–4995
— 0
— 0
Value Range
SO2-LOW, Gas and range to calibrate
during contact-closure and
SO2-HIGH,
Hessen calibration. Enclose
H2S-LOW,
value in double quotes (")
when setting from the RS-
H2S-HIGH,
232 interface.
6
TRS-LOW ,
6
TRS-HIGH
OFF, ON ON holds D/A outputs during
zero/span calibration; OFF
permits D/A outputs to
change.
OFF, ON ON enables passwords; OFF
disables them.
0.5–30 Reaction cell temperature
control cycle period.
0–10 Reaction cell temperature
PID proportional coefficient.
0–10 Reaction cell temperature
PID integral coefficient.
0–10 Reaction cell temperature
PID derivative coefficient.
0.5–30 IZS temperature control
cycle period.
0–10 IZS temperature PID
proportional coefficient.
0–10 IZS temperature PID integral
coefficient.
0–10 IZS temperature PID
derivative coefficient.
0–2000 High voltage power supply
warning limits. Set point is
not used.
0–5000 PMT detector maximum
warning limit.
0–5000 Pre-amplified UV lamp
minimum/maximum warning
limits. Set point is not used.
0–5000 UV lamp minimum/maximum
warning limits. Set point is
not used.
0–65535 Electrical test level setting.
0–65535 Optical test level setting.
Description
07266B DCN6485