Table 4-11. Analog Output Current Loop Range; Table 4-12. Analog Output Pin Assignments - Teledyne T101 Operation Manual

Operating Instructions
RANGE
0-20 mA
These are the physical limits of the current loop modules, typical applications use 2-20 or 4-20
mA for the lower and upper limits. Please specify desired range when ordering this option.
The default offset for all ranges is 0 mA.
86
The following DC current output limits apply to the current loop modules:

Table 4-11. Analog Output Current Loop Range

MINIMUM OUTPUT
Pin assignments for the output connector at the rear panel of the instrument are shown in
Table 4-12.
A1
+ - +

Table 4-12. Analog Output Pin Assignments

PIN
ANALOG
OUTPUT
1
A1
2
3
A2
4
5 A3
7
A4
8
See Figure 3-4 for the location of the analog output connector on the instrument's rear
panel.
Teledyne ML – T101 Operation Manual
0 mA
ANALOG OUT
A2 A3 A4
- + - +
VOLTAGE CURRENT
SIGNAL SIGNAL
V Out I Out +
Ground I Out -
V Out I Out +
Ground I Out -
Not Used Not Used
V Out not available
Ground not available
MAXIMUM OUTPUT
20 mA
-