Analog Output Calibration Mode - Teledyne T101 Operation Manual

Operating Instructions

4.6.3.2. Analog Output Calibration Mode

Exit at any time
to return to the
main DIAG
menu
If any of the channels have
not been calibrated this
message will read NO.
88
Analog output calibration should be carried out on first startup of the analyzer (performed
in the factory as part of the configuration process) or whenever recalibration is required.
The analog outputs can be calibrated automatically, either as a group or individually, or
adjusted manually.
In its default mode, the instrument is configured for automatic calibration of all channels,
which is useful for clearing any analog calibration warnings associated with channels that
will not be used or connected to any input or recording device, e.g., datalogger.
Manual calibration should be used for the 0.1V range or in cases where the outputs must
be closely matched to the characteristics of the recording device. Manual calibration
requires the AUTOCAL feature to be disabled.
To calibrate the outputs as a group, activate the ANALOG I/O configuration menu (see
Section 4.6.3), then press:
STARTING FROM DIAGNOSTIC MENU
(see Section 6.9.1)
DIAG ANALOG I / O CONFIGURATION
PREV NEXT
DIAG AIO AOUTS CALIBRATED:
< SET SET> CAL
DIAG AIO AUTO CALIBRATING CONC_OUT_1
AUTO CALIBRATING CONC_OUT_2
AUTO CALIBRATING TEST_OUTPUT
DIAG AIO AOUTS CALIBRATED:
< SET SET> CAL
Teledyne ML – T101 Operation Manual
ENTR EXIT
NO
If AutoCal has been
EXIT
channel, the message
for that channel will be
YES
EXIT
turned off for any
similar to:
NOT AUTO CAL
CONC_OUT_1
Exit to return to
the I/O
configuration
menu