Omron CS1G/H-CPUxxH Instructions Manual page 217

Sequence Control Instructions
Applicable Program Areas
Operands
Operand Specifications
Description
196
Variations Jumps when OFF/Doesn't jump when ON
Immediate Refreshing Specification
Variations Executed Each Cycle for ON Condition
Immediate Refreshing Specification
Block program areas
OK Not allowed
N: Jump Number
The jump number must be 0000 to 03FF (0 to 1,023 decimal).
Area
CIO Area CIO 0000 to CIO 6143
Work Area W000 to W511
Holding Bit Area H000 to H511
Auxiliary Bit Area A000 to A959
Timer Area T0000 to T4095
Counter Area C0000 to C4095
DM Area D00000 to D32767
EM Area without E00000 to E32767
bank
EM Area with bank En_00000 to En_32767
(n = 0 to C)
Indirect DM/EM @ D00000 to @ D32767
addresses in binary
@ E00000 to @ E32767
@ En_00000 to @ En_32767
(n = 0 to C)
Indirect DM/EM *D00000 to *D32767
addresses in BCD
*E00000 to *E32767
*En_00000 to *En_32767
(n = 0 to C)
Constants #0000 to #03FF (binary) or &0 to &1023
Data Registers DR0 to DR15
Index Registers ---
Indirect addressing ,IR0 to ,IR15
using Index Regis-
–2048 to +2047, IR0 to –2048 to +2047,
ters
IR15
DR0 to DR15, IR0 to IR15
The operation of CJP(510) and CJPN(511) differs only in the execution condi-
tion. CJP(510) jumps to the first JME(005) when the execution condition is ON
and CJPN(511) jumps to the first JME(005) when the execution condition is
OFF.
Because the jumped instructions aren't executed, the cycle time is reduced by
the total execution time of the jumped instructions.
Step program areas Subroutines
OK
N
CJP(510) CJPN(511)
Section 3-5
CJPN(511)
Not supported
JME(005)
Not supported
Interrupt tasks
OK
JME(005)
---
---
---
---
---
---
---
---
---
---
---
#0000 to #03FF
(binary) or &0 to
&1023
---
---
---