Omron CS1G/H-CPUxxH Instructions Manual page 877

Serial Communications Instructions
Related Flags and Words
856
The following PLC Setup settings and Auxiliary Area flag can be used as
required when executing TXD(236).
PLC Setup
Name
No-protocol Mode Specifies if a start code is to be used in the
Start Code frame format for no-protocol mode communi-
cations.
No-protocol Mode End Specifies if an code is to be used in the frame
Code format for no-protocol mode communications.
No-protocol Mode The specified data will be sent from the port
Send Delay only after the specified delayed time has
elapsed from the time TXD(236) was executed
in the ladder program.
Auxiliary Area
Name
RS-232C Port Send Ready
Flag
Contents
Address
A39205 ON when data can be sent in the no-
protocol mode.
Section 3-24
Setting
0: None
(default)
1: Yes
(set 00 to
FF hex)
0: None
(default)
1: Yes
(set 00 to
FF hex or
CR+LF)
0 to 99990
ms
(in 10-ms
units)
Default:
0 ms
Contents