Omron CS1G/H-CPUxxH Instructions Manual page 197

Sequence Output Instructions
Applicable Program Areas
Operand Specifications
Description
176
Variations Executed Each Cycle for ON Condition
Executed Once for Upward Differentiation
Executed Once for Downward Differentiation %RSET
Immediate Refreshing Specification (See note.)
Combined Immediate Refreshing Once for Upward
Variations Differentiation (See note.)
Immediate Refreshing Once for Downward
Differentiation (See note.)
Note Immediate refreshing is not supported by the CS1D CPU Units.
Block program areas
OK
Area
CIO Area
Work Area
Holding Bit Area
Auxiliary Bit Area
Timer Area
Counter Area
DM Area
EM Area without bank
EM Area with bank
Indirect DM/EM
addresses in binary
Indirect DM/EM
addresses in BCD
Constants
Data Registers
Index Registers
Indirect addressing
using Index Registers
SET turns the operand bit ON when the execution condition is ON, and does
not affect the status of the operand bit when the execution condition is OFF.
Use RSET to turn OFF a bit that has been turned ON with SET.
RSET turns the operand bit OFF when the execution condition is ON, and
does not affect the status of the operand bit when the execution condition is
OFF. Use SET to turn ON a bit that has been turned OFF with RSET.
Step program areas
OK OK
CIO 000000 to CIO 614315
W00000 to W51115
H00000 to H51115
A44800 to A95915
---
---
---
---
---
---
---
---
---
---
,IR0 to ,IR15
–2048 to +2047, IR0 to –2048 to +2047, IR15
DR0 to DR15, IR0 to IR15
,IR0+(++) to ,IR15+(++)
,–(– –) IR0 to ,–(– –) IR15
Execution condition
of SET
Status of B
Section 3-4
RSET
@RSET
!RSET
!@RSET
!%RSET
Subroutines Interrupt tasks
OK
B