116-382 ABL Initialize RAP
HDD access by the ABL (Address Book Library) failed.
Initial Actions
Power Off/On
Set ChainLink 790-664 to 0.
If the problem persists, replace the NVM component on the NVM Controller.
Procedure
•
Check the HDD electrical connections
•
Check the sw version of the controller sw - update if required
•
If the problem persists perform
Hard Disk Failure Prediction
•
Perform
GP 14
- only the first two parts - make sure to follow sequence and heed cau-
tions
1.
Job Log Clear Mode
2.
HDD Initialize Mode
•
Replace HDD
(PL
35.2)
•
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB)
Status Indicator RAPs
116-382, 116-383
(PL
35.2).
Test.
BUS Updated 12/2011
116-383 PIT Lib Failure RAP
PIT Lib Failure.
Initial Actions
Power Off/On
1.
It was detected that the Image Extension Kit (Ama + toto board) was not installed on the
ESS PWB
(PL
35.2) during job execution.
2.
An Ama + toto board failure was detected during job execution.
3.
An HDD access error was detected during job execution.
NOTE: Although 016-231 is detected during power ON, this fail is a "job execution detec-
tion" and has a different timing.
Procedure
•
(1) (2) After turning the power OFF then ON, check the panel top right display to see
whether 016-231 has occurred, without this error (= 116-383) occurring.
If 016-231 has occurred, perform the corrective actions for 016-231.
If the error does not occur, proceed to (3) for the HDD access error.
If the problem persists, perform the following procedure to repair it.
•
Check the HDD electrical connections
•
Check the sw version of the controller sw - update if required
•
If the problem persists perform
•
Perform
GP 14
- only the first two parts - make sure to follow sequence and heed cau-
tions
1.
Job Log Clear Mode
2.
HDD Initialize Mode
•
Replace HDD
(PL
35.2)
•
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB)
07/2011
2-880
(PL
35.2).
Hard Disk Failure Prediction
Test.
WorkCentre 5335 Family Service Documentation
Initial Issue