Rep 5.12 Dadf Registration Motor - Xerox workcentre 5335 series Service Manual

Figure 6 J753 Harness Hook
Initial Issue
WorkCentre 5335 Family Service Documentation

REP 5.12 DADF Registration Motor

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the DADF Front Cover.
3. Remove the DADF Rear Cover.
4. Remove the DADF.
5. Remove the DADF Document Tray.
6. Remove the DADF Feeder Assembly.
7. Remove the Registration Chute.
8. Remove the Top Cover.
9. Remove the Harness Guide and the wire harness.
10. Remove the DADF Registration Motor.
(1) Remove the spring.
(2) Remove the screws (x2).
(3) Remove the DADF Registration Motor.
Replacement
1. To install, carry out the removal steps in reverse order.
2. Install the Belt (A) to the Pulley of the DADF Registration Motor.
(A)Belt
07/2011
4-25
BUS Updated 12/2011
PL 51.5
(REP 5.3)
(REP 5.4)
(REP 5.1)
(REP 5.9)
(REP 5.5)
(REP 5.14)
(REP 5.10)
(REP
(Figure 1)
Figure 1 DADF Reg Motor
5.11)
(Figure 2)
Repairs & Adjustments
REP 5.11, REP 5.12