Adj 5.2 Dadf Side Registration - Xerox workcentre 5335 series Service Manual

ADJ 5.2 DADF Side Registration

Parts List on PL 51.1
Purpose
To adjust the original to the proper position (drum shaft direction) on the Platen.
NOTE: The following adjustments must be made before carrying out checking and adjustment.
• IOT Lead Edge/Side Edge Registration
• IIT Side Registration (ADJ 6.4)
• DADF Lead-Skew Adjustment (ADJ 5.1)
NOTE: DADF Side Registration is adjusted using the NVM for every paper width.
Check
Create a test pattern
1. To create a Cross Line Test Pattern, use a plain white sheet of 8.5x11"/A4 paper and fold
the sheet precisely in half lengthwise and width wise. Then with a straight edge draw a
straight line in the lengthwise crease and a straight line in the width wise crease.
Label the top for orientation purposes.
Initial Issue
WorkCentre 5335 Family Service Documentation
(ADJ 9.10)
(Figure 1)
BUS Updated 12/2011
A
Figure 1 Creating a Test Pattern Original
DADF Side Edge Registration Check - Side 1
1. Load Tray 1 with 8.5x11"/A4 paper.
2. Place the new Cross Line Test Pattern on the DADF with the word TOP Face Up and
towards the rear of the DADF.
3. Select the following:
• Tray 1
• 1-1 Sided.
• 100%
• 1 copy
4. Make one copy to the center tray.
5. Remove the copy from the center tray and Flip the copy left to right.
6. Fold the copy in half parallel to the short edge (A to B in
7. Check that the fold line is within 2.0mm from the reference line. If the value is not within
the specified range, perform the Side 1 Adjustment. If the Check is OK, perform the
DADF Side Edge Registration Check - Side 2.
07/2011
4-191
TOP
B
Figure 1).
Repairs & Adjustments
ADJ 5.2